Direct Factory brushed brass gold bathroom mirror Supplier - Bulk Supply and Specification Guide
What This Product Is and Where It Fits
Total cost of ownership shifts once returns are counted. A bathroom mirror with a brass frame is sold on appearance, but it is judged in service by how the frame finish handles condensation, cleaning agents, and repeated handling during installation. Importer and club purchasing decisions that look only at unit price usually miss the replacement cycle that follows coating failure or edge corrosion.
Brushed brass gold is a surface finish, not a solid metal construction in most bulk programs. The frame is typically brass or brass-coated aluminium, while the glass is copper-free silver mirror to limit black-edge formation in humid rooms. Where the glass meets the frame, the sealant and backing determine whether moisture reaches the reflective coating. Buyers should agree the sealant chemistry in the sample stage rather than assume standard silicone.
Materials and Construction Trade-offs
| Construction option | Frame substrate | Surface finish | Humidity behaviour | Typical tooling impact |
|---|---|---|---|---|
| Brushed brass PVD | Solid brass | Physical vapour deposition | Resists tarnish and fingerprints; shows scratches less than polished brass | Higher tooling, longer lead time |
| Electroplated brass | Steel or brass | Electrodeposited brass layer | Can plate through at cut edges in constant moisture | Moderate tooling |
| Brass-finish foil | Aluminium or MDF | Printed or laminated foil | Delaminates at mitres after repeated wetting cycles | Lowest tooling, fastest sample |
Size, Weight and Specification Range
Glass thickness and frame width set the dead weight that the wall fixing must carry. A 600 x 800 mm unit with 4 mm float glass and a 30 mm brass frame usually lands between 4.5 and 6 kg depending on backing board.
Larger sizes move to 5 mm glass and a French cleat instead of a single D-ring, which changes the screw layout and load distribution. Tolerances on frame mitre and glass edge polish affect how the mirror sits against the wall.
A 1 mm gap at the top corner invites silicone sealant that yellows over time, while a tight fit transfers frame expansion directly to the glass edge.
How Consistency Is Held Across Batches
Mechanical cleat mounting
The cleat carries the load through two points and lets a unit slide off for replacement without disturbing wall fixings. Rework time per mirror is under five minutes.
Adhesive-only mounting
Mirror mastic bonds the frame directly to the wall. Removal risks frame distortion or glass edge chip, so replacement usually means new fixings and a new mirror.
What Gets Checked Before Shipment
Each shipment is checked against the approved drawing, not against a general catalogue spec.
| Packaging level | Contents | Protection method | Unit weight estimate | Pallet configuration |
|---|---|---|---|---|
| Individual mirror | Frame, glass, fixings | Foam corner guards, polyethylene wrap, cardboard sleeve | 4.5-7 kg | 10-16 units per carton |
| Master carton | 4-6 individually packed units | Double-wall carton, corner posts, strapping | 22-40 kg | 24-36 cartons per pallet |
| Export pallet | Full master cartons | Heat-treated pallet, stretch wrap, top cap | 500-800 kg | Loaded for full-container or LCL shipment |
Setup, Use and Replacement Parts
Replacement parts should mirror the original fixing specification rather than substitute hardware from a different frame line. Cleaning cloths should be microfibre and free of grit, because brushed finishes show abrasion more readily than polished surfaces.
Do not use acidic or abrasive cleaners on brushed brass. Wipe condensation from the frame edge within 24 hours in steam rooms to prevent coating failure at the mitre joints.
Request a pre-production sample to confirm frame finish, glass thickness, and packaging configuration before the first production run. Samples ship within the quoted lead time and carry the same tolerances as the production batch.
